Hi,
Where can one purchase the special markerpen you use to mark the center for drilling holes. It appears to me like something you push down but then I can heard a 'tok' like the pin is punching itself into the wood. It that correct and if so, where did you find this?
Secondly, you use modified drills where you sharpened a point on it to ease centering the drill. How did you make these? Things one should pay attention to?
Thx
Marc Engrie
looking for
-
- Posts: 2250
- Joined: Thu Oct 22, 2015 4:51 pm
-
- Posts: 4
- Joined: Sun Mar 20, 2022 1:14 pm
Re: looking for
center hole punch found thx.
however the drill I was referring to is (see image). Does not look like a CMT drill but more like a normal drill but adjusted ...
however the drill I was referring to is (see image). Does not look like a CMT drill but more like a normal drill but adjusted ...
-
- Posts: 2250
- Joined: Thu Oct 22, 2015 4:51 pm
Re: looking for
It is the same drill bit that I have linked to you in the previous answer, but longer. The one in the second photo. It's called "through hole drill bit"