Page 1 of 1
Saw blade sharpening jig
Posted: Wed Oct 24, 2018 1:31 pm
by Suso
I need to sharpen all of my table saw blades, so I've decided to make a simple
sharpening jig to streamline and improve the process. Stay tuned!
ArtÃculo en el blog:
Re: Saw blade sharpening jig
Posted: Thu Oct 25, 2018 3:43 pm
by Suso
I've just finished designing my new saw blade sharpening jig. This is the 3D model I've been working on over the last few days. I'm going to use an angle grinder with a grinding wheel, I hope it works!
Re: Saw blade sharpening jig
Posted: Mon Oct 29, 2018 12:17 pm
by Suso
I've started the saw blade sharpening jig. I've cut its base and the piece that will allow me rotate the angle grinder.
Re: Saw blade sharpening jig
Posted: Tue Oct 30, 2018 5:34 pm
by Suso
I just finished my new table saw blade sharpening jig,
here youll find more info and the plans:
Sharpening jig Readers Projects:
Re: Saw blade sharpening jig
Posted: Sun Apr 12, 2020 4:23 pm
by gamber
With these plans, which is the largest saw blade which can be sharpened?
I have a number of timber saws with blades up to 427.5mm in diameter I wish to sharpen. It is my assumption that I can make the base larger, and increase the travel of the drawer slides. For example if the plans allow for 305mm blades, I should be able to increase the travel by 61 mm, (427-305)/2. Is this a correct assumption?
Re: Saw blade sharpening jig
Posted: Sun Apr 12, 2020 5:30 pm
by Suso
hello mate,
yes, if you make tha base larger and you install the guides of the necessary length you will not have problems.