Thanks Suso for offering plans for your project. I am very happy with my saw and your instructions are the best and most detailed I have ever saw online. I used 3/4" and 1/2" MDO plywood for my project. It is not the best looking wood, but it is very stable and does not warp. It has a resin mixture on the top coat and I added coats of oil based poly for extra protection. I added four switches to contol my saw, jigsaw, router, and shop vacuum. The only complaint I have is I do not like the design for the saw fence. I have built two and neither is square to the blade due to small inaccuracies during the build. Some day I will design something better.
This is my finished saw:
I have a bad back and I wanted my measurement scale visible from the top. If I need measurements cut off by the track I'll have to measure. Easy trade off for speed of adjustment. I put a second tape on the exit side to stay square:
Inside view of electrical. I used conduit to prevent dust and fires:
Router lift:
Back side with elecrical entry NEMA L20:
My first project:
![Image](http://paoson.com/uploadPics/uploads/20161120_221757.jpg)