Peter Van De Meent Plywood Workbench
Posted: Mon May 25, 2020 7:59 am
Made Some steel brackets on the legs. The wood was splitting while moving the bench. Good luck tearing this out! 4mm galvanized steel
Forum - Paoson Woodworking
Woodworking Forum
https://www.paoson.com/forum/
Peter Van De Meent Plywood Workbench
Page 1 of 1
Re: Peter Van De Meent Plywood Workbench
Posted: Mon Jun 22, 2020 10:46 am
more photos:
Made Some steel brackets on the legs. The wood was splitting while moving the bench. Good luck tearing this out! 4mm galvanized steel
Made Some steel brackets on the legs. The wood was splitting while moving the bench. Good luck tearing this out! 4mm galvanized steel
Re: Peter Van De Meent Plywood Workbench
Posted: Mon Aug 10, 2020 9:30 am
finished workbench:
DIY workbench slab flattening jig
Posted: Sun Dec 05, 2021 8:20 pm
@peerenhout:
I ordered Some linear rails of 220cm from aliexpress to make a slab flattening jig. Since I have limited space I use my #multifunctionalworkbench from @paoson_woodworking as work space.
Some m4 nuts in the bench, so I have the rails exactly level, and Some m4 screws so I can take the rails of when not needed.
A pair of shorter rails of 120cm to replace the wooden tray. Now I can flatten bigger slabs and cutting boards!
I ordered Some linear rails of 220cm from aliexpress to make a slab flattening jig. Since I have limited space I use my #multifunctionalworkbench from @paoson_woodworking as work space.
Some m4 nuts in the bench, so I have the rails exactly level, and Some m4 screws so I can take the rails of when not needed.
A pair of shorter rails of 120cm to replace the wooden tray. Now I can flatten bigger slabs and cutting boards!
DIY workbench slab flattening jig
Posted: Sun Dec 05, 2021 8:21 pm
