Share your woodworking projects!
-
Suso
- Posts: 2325
- Joined: Thu Oct 22, 2015 4:51 pm
Post
by Suso » Fri Oct 01, 2021 7:43 am
From Canada we get this wonderful version of the Modular Workbench, made by Marco. He wrote me:
Hi Suso. Please see photos attached. I have not drilled the 20mm holes in the top yet. I'm planning to change the top to solid maple. I also did not add the vise as I have one set up already elsewhere.
I love this workbench. Can't wait to make the Multi-Function Workbench. I will be ordering those plans soon. Thank you for all your help.
Marco
-
ModernMayhem
- Posts: 1
- Joined: Fri Dec 03, 2021 4:38 pm
Post
by ModernMayhem » Fri Jan 14, 2022 4:46 am
@Marco @Suso
Would you mind posting the source for your flush drawer-pulls? I’d like to use the same if you don’t mind. Thanks.
-
Suso
- Posts: 2325
- Joined: Thu Oct 22, 2015 4:51 pm
Post
by Suso » Mon Jan 17, 2022 8:39 am
hi mate,
here you'll find that
drawer-pulls:
-
jb510
- Posts: 6
- Joined: Tue Jun 18, 2024 4:32 am
Post
by jb510 » Fri Feb 14, 2025 4:26 pm
Found this after building my drawers... but someday I'm going to rebuild them like this. Love the flush look. I assume you built these as full (4 side) drawer boxes and then put on a drawer face? with the alumnimum channel supported against the drawer box?
I built mine where the face is actually part of the drawer box. Works, less material obviously which makes them lighter (most of the reason I did it). But lining up the drawer faces and reveals was difficult.
