Mobile Workbench by Marc Engrie
Posted: Tue May 03, 2022 4:17 pm
Forum - Paoson Woodworking
Woodworking Forum
https://www.paoson.com/forum/
Mobile Workbench by Marc Engrie
Page 1 of 1
Re: Mobile Workbench by Marc Engrie
Posted: Tue May 03, 2022 4:19 pm
Finished Workbench:
Re: Mobile Workbench by Marc Engrie
Posted: Tue May 03, 2022 4:19 pm
DIY Table Saw Sled and Sliding Carriage:
Re: Mobile Workbench by Marc Engrie
Posted: Mon Jan 16, 2023 11:27 pm
Where can I get/ buy the that aluminum profile fence? I can't find it anywhere here in the united states.
Online purchase?
Online purchase?
Re: Mobile Workbench by Marc Engrie
Posted: Fri Feb 03, 2023 8:46 am
I got it from AliExpress.... most of the times that's cheaper than via Amazon.... most of the time Amazon deliver these products from AliExpress sellers
Re: Mobile Workbench by Marc Engrie
Posted: Fri Jan 12, 2024 1:30 pm
Marc wrote me:
I just finish an idea to improve my mobile workbench, based upon yours, with an MFT -table. It has 20mm for bench dogs and tools based on that system as well as groves to support the MicroJig system. All holes and groves have been chamfered to prevent sticking material against it while sliding over. I tested sawing panels and they still glide smoothly over it.
NB: groves are chamfered by the router bit already.
Next might be to add a vertical panel with the same pattern of holes and groves but I am still thinking on what the best way might be for this
I just finish an idea to improve my mobile workbench, based upon yours, with an MFT -table. It has 20mm for bench dogs and tools based on that system as well as groves to support the MicroJig system. All holes and groves have been chamfered to prevent sticking material against it while sliding over. I tested sawing panels and they still glide smoothly over it.
NB: groves are chamfered by the router bit already.
Next might be to add a vertical panel with the same pattern of holes and groves but I am still thinking on what the best way might be for this