Page 1 of 1

looking for

Posted: Sat Mar 26, 2022 7:23 pm
by mengrie
Hi,

Where can one purchase the special markerpen you use to mark the center for drilling holes. It appears to me like something you push down but then I can heard a 'tok' like the pin is punching itself into the wood. It that correct and if so, where did you find this?

Secondly, you use modified drills where you sharpened a point on it to ease centering the drill. How did you make these? Things one should pay attention to?

Thx

Marc Engrie

Re: looking for

Posted: Sat Mar 26, 2022 8:13 pm
by Suso
hi mate,

I think you mean a center hole punch:

I think these are the bits you are looking for.

Re: looking for

Posted: Sun Mar 27, 2022 11:56 am
by mengrie
center hole punch found thx.

however the drill I was referring to is (see image). Does not look like a CMT drill but more like a normal drill but adjusted ...

Image

Re: looking for

Posted: Mon Mar 28, 2022 8:25 am
by Suso
It is the same drill bit that I have linked to you in the previous answer, but longer. The one in the second photo. It's called "through hole drill bit"