Scroll Saw

Discuss topics related to the Portable Workshop
Post Reply
rt@webspeed.dk
Posts: 4
Joined: Sun May 05, 2019 12:59 pm

Scroll Saw

Post by rt@webspeed.dk » Sun May 05, 2019 1:39 pm

HI
I have now made the Scroll Saw application to my Portable Workshop (as I am very fond of), but have met an unexpected problem with the distance between the jig saw chuck and the table surface which is less than the jigsaw stroke. Furthermore the jigsaw blade seen on the printable template can be measured to 50 mm long, but in my case a jig saw blade is mounted much deeper in the chuck in its lowest position and the 4 mm hole for the mounting screw for the scroll saw blade, would be "buried" in the chuck.
The actual jig saw is Festool 300 EQ.
I wonder what the secret is when I look at your demonstration of a working scroll saw ?
Regards Robert

Suso
Posts: 2236
Joined: Thu Oct 22, 2015 4:51 pm

Re: Scroll Saw

Post by Suso » Sun May 05, 2019 7:23 pm

hello Robert,

could you upload some photo showing the problem?

Post Reply