hi
I'm building my portable workshop with phenolic plywood top. The problem i'm having is what would be the best way to mark-out for routing and drilling ? white paint pen ?
or print out 32 pages of PDF's cut ,tape, and spray adhesive to surface ?
any other ideas i would love to hear.
keith
Marking out and routing
-
- Posts: 2243
- Joined: Thu Oct 22, 2015 4:51 pm
Marking out and routing
hi Keith,
in such large areas as in this case, I think the best way is as I did, check the measures in the plans and mark onto the plywood board with a measuring tape and a pencil.
To make the milling, you could use a template like this:
Homemade Adjustable Routing Template
in such large areas as in this case, I think the best way is as I did, check the measures in the plans and mark onto the plywood board with a measuring tape and a pencil.
To make the milling, you could use a template like this:
Homemade Adjustable Routing Template
-
- Posts: 2
- Joined: Mon Aug 29, 2016 12:16 pm
Marking out and routing
thanks for the reply Suso
so you have no problems marking the rough/bumpy side of the board with a pencil and keep accuracy ? my eyesight is not as good as it used to be :( . and i'm not as skilled as you.
but i will give it a try. could always swap it to Baltic birch and use the phenolic board on another of your projects.
thanks keith
so you have no problems marking the rough/bumpy side of the board with a pencil and keep accuracy ? my eyesight is not as good as it used to be :( . and i'm not as skilled as you.
but i will give it a try. could always swap it to Baltic birch and use the phenolic board on another of your projects.
thanks keith