Some questions for Project construction

Post by **Suso** » Fri Mar 11, 2016 9:19 am

Hi Gianvador:
For your garage-workshop I`d go with the fist one too!

quert · Post by **quert** » Fri Mar 11, 2016 4:44 pm

Hey,
I have another question about the plywood sheets. In the "plans" video, i can see youre using three sheets. What are the dimensions of these? 2500x1500?

Greets!

Post by **Suso** » Fri Mar 11, 2016 5:38 pm

Hi Jork:

Usually the dimensions of this sheets is 2500X1250mm

nerobond · Post by **nerobond** » Thu Mar 17, 2016 6:58 pm

hello I wanted to ask where I can find the tool to make holes for the anchors , the project is coming really well , look your daniele hello response

Post by **Suso** » Fri Mar 18, 2016 8:30 am

Hi,
If you are talking about the threaded inserts, you can do it with a regular drill bit

Drill diameter = "E"
Hole Deep = "C"

nerobond · Post by **nerobond** » Sat Mar 19, 2016 7:54 am

No, I did not mean those threaded , but the tool that is seen in the video to put those wooden

Post by **Suso** » Mon Mar 21, 2016 9:20 am

Hi,
I am making a video showing how to make a dowel jig!

I think it will be ready in a few days

nerobond · Post by **nerobond** » Mon Mar 21, 2016 8:05 pm

I believed that you had bought , still looks the video hello daniele

NOFX · Post by **NOFX** » Tue Jun 28, 2016 11:24 am

wrote:Hi,
If you are talking about the threaded inserts, you can do it with a regular drill bit

Drill diameter = "E"
Hole Deep = "C"

Hi i have buy these inserts m8x25mm can i use them? I can to cut a little the final part (on 18 mm wood)
Excuse my english :-)

Post by **Suso** » Tue Jun 28, 2016 1:51 pm

Hi,
They may be worth, you must cut up 18mm