Hey everyone,
I don't see a way to lower or rise the castor wheels when the workbench is placed at a wall and two modules are joint together to make a longer workbench or when a module should be placed in a corner because you can't reach the wheels anymore. Right?
That would mean when using caster wheels you can only place a single module at a wall and have to make sure it's not in a corner or you use multiple modules in the middle of the workshop.
Am I overseeing something here?
Where to Find Wheels
-
- Posts: 2247
- Joined: Thu Oct 22, 2015 4:51 pm
Re: Where to Find Wheels
hi HerrLux ,
It's the problem with these wheels. In my case I have noticed that just lowering the pad of the front wheels a little is enough to block the modules. You can also screw some stops to the wall to block them.
It's the problem with these wheels. In my case I have noticed that just lowering the pad of the front wheels a little is enough to block the modules. You can also screw some stops to the wall to block them.
-
- Posts: 4
- Joined: Tue Feb 28, 2023 12:50 pm
Re: Where to Find Wheels
Thanks Suso!
I was thinking if something like this would be a solution in my case:
https://www.youtube.com/watch?v=MrtiDfJGlhE
However, if I join two modules together on the short side, again I won't be able to reach the mechanism.
So I guess I will go with your proposed solution and install some stops on the wall
I was thinking if something like this would be a solution in my case:
https://www.youtube.com/watch?v=MrtiDfJGlhE
However, if I join two modules together on the short side, again I won't be able to reach the mechanism.
So I guess I will go with your proposed solution and install some stops on the wall