Motor for Sanding Disc or Lathe
Posted: Wed May 22, 2019 11:01 am
Hi,
I have a circular saw (for table) motor.
Writes the following information on the engine => 800W, 2950 rpm, asynchronous, 230V and 50hz.
No HP information.
Can this engine be used in the Thickness Sander or Lathe project?
I have a circular saw (for table) motor.
Writes the following information on the engine => 800W, 2950 rpm, asynchronous, 230V and 50hz.
No HP information.
Can this engine be used in the Thickness Sander or Lathe project?