bearing in place of the blade guide

[lightmooner]

Hello,

Would it be a good idea to replace those HPL guide by bearings ? if so which ones ?

also, on the fastener list, you specify ZZ bearing for the guides, why not RS (to protect from dust)

Are the 6204 bearing (supporting shaft) RS ?

Thanks

[Suso]

hi mate,

I have not had problems with the 6204 bearing in the shaft, but if you wish you can install a RS one. For the guides it's better to have a sealed or RS bearing. Regarding the material, HPL works perfectly and it's a matter of preferences. Bearings make more noise when working, but both methods are valid.

[lightmooner]

would you consider those for the shaft ?

they are self aligning, allowing the shaft to rotate a little bit if everything isn't perfectly at 90 degrees.

demo : https://www.youtube.com/watch?v=9rLP-p4R3pg

thanks for taking the time to answer !

[Suso]

sure, that type of bearing will make your work easier and it will work perfectly.