from the sliding carriage to the end of the router table there is 1250mm, so you should think about using the 1320mm profile. It's how I did it and you can see in the video.
I don't understand what you mean by "How much of the fence"
Using a different bench table saw?
-
- Posts: 6
- Joined: Wed Jan 24, 2024 7:20 pm
Re: Using a different bench table saw?
Thank you. You answered my questions, my wording was confusing. I was asking wheat length of the Axminister fence you ended up using.
-
- Posts: 2242
- Joined: Thu Oct 22, 2015 4:51 pm
Re: Using a different bench table saw?
perfect Hungry_J0e, I would like to see photos of your progress!
-
- Posts: 6
- Joined: Wed Jan 24, 2024 7:20 pm
-
- Posts: 2242
- Joined: Thu Oct 22, 2015 4:51 pm
-
- Posts: 3
- Joined: Fri Apr 05, 2024 3:08 am
Re: Using a different bench table saw?
Don't know about the other person, but I CAN see the "New Topic" button in the "Readers Project Showcase" section, but I do NOT see that "New Topic" button pretty much anywhere else. (Most notably, not in this "Mobile Workbench with Table Saw & Router Table" discussion area.)Suso wrote: ↑Mon Jan 29, 2024 9:44 amcan't you see the button "New Topic" in this section at the top left?
Readers Project Showcase