Table Saw Folding Outfeed Table & CrossCut Sled

Discuss topics related to the Folding Woodworking Workstation
Suso
Posts: 2217
Joined: Thu Oct 22, 2015 4:51 pm

Re: Table Saw Folding Outfeed Table & CrossCut Sled

Post by Suso » Fri Nov 17, 2023 2:54 pm

How I made the adjustable zero clearance of my new table saw sled. First I've used the router table to make the rebate required. After that I've made the holes for the threaded inserts. Then I've set up the router table to make the final cuts to use these zero clearance inserts. I've used the miter gauge and a stop so that all the rebates are the same. Link to the full video in my bio!


Suso
Posts: 2217
Joined: Thu Oct 22, 2015 4:51 pm

Re: Table Saw Folding Outfeed Table & CrossCut Sled

Post by Suso » Fri Nov 24, 2023 2:02 pm

These are the two plywood sliders I made so that I can use my new table saw sled. I've designed them to be detachable so I can use the sled as part of the outfeed table. In order to set them up more quickly and accurately, I've used some pieces of a steel pipe and some round neodymium magnets of the same diameter as the pipe. I don't think the magnet is indispensable in order to use this system.


Post Reply