fabrication of "V" rails or tracks

Discuss topics related to the 3D Router & the X-Motion Portable Mortiser
Post Reply
JoeM1
Posts: 1
Joined: Mon Feb 12, 2018 11:26 pm

fabrication of "V" rails or tracks

Post by JoeM1 » Mon Feb 12, 2018 11:35 pm

Suso,
Do you measure and adjust the distance between the peaks for the aluminum rails??
I guess if you saw any large variation in the distance you could add a small shim to try minimize the variation, or is this not of importance in your design??
Just wondering, I'm an enginerd...

Your projects are fantastic and inspiring... do you have a design or engineering background?
muchas gracias,
J.M.

Suso
Posts: 2228
Joined: Thu Oct 22, 2015 4:51 pm

fabrication of "V" rails or tracks

Post by Suso » Tue Feb 13, 2018 11:34 am

hello Joseph,
as you say, you must measure the distance between the peaks of the "L" steel profile, and if there is variation you can correct it by adding a small shim.

Post Reply