Suso,
Do you measure and adjust the distance between the peaks for the aluminum rails??
I guess if you saw any large variation in the distance you could add a small shim to try minimize the variation, or is this not of importance in your design??
Just wondering, I'm an enginerd...
Your projects are fantastic and inspiring... do you have a design or engineering background?
muchas gracias,
J.M.
fabrication of "V" rails or tracks
-
- Posts: 2242
- Joined: Thu Oct 22, 2015 4:51 pm
fabrication of "V" rails or tracks
hello Joseph,
as you say, you must measure the distance between the peaks of the "L" steel profile, and if there is variation you can correct it by adding a small shim.
as you say, you must measure the distance between the peaks of the "L" steel profile, and if there is variation you can correct it by adding a small shim.