Question

lisimario · Post by **lisimario** » Sat Nov 21, 2015 8:24 am

Good morning.
I saw today, your videos on YouTube, these are very interesting and well done.
I would like to make to you a question about the support for the router Kreg you see in the video no. 8 of the series "Making 3D router". I have the same router but was not able to find the support; you can tell me where you bought such support?
Tankyou
Best regards.
Mario

lisimario · Post by **lisimario** » Sat Nov 21, 2015 6:35 pm

Sorry the router is Kress and not Kreg.

Post by **Suso** » Mon Nov 23, 2015 8:18 am

Hi,
I did it myself with hard plywood, you can see it in other videos.
You can also use this:

http://cnc-plus.de/en/Router-Accessories/Euro-Neck-Spindle-Mount--73x73x20mm-Bracket-Clamp-.html

lisimario · Post by **lisimario** » Mon Nov 23, 2015 1:48 pm

Thank you.
But I have not been clear.
The support I meant was that in the Making a 3D Router (Part8) at minute 3:50 and you use the router hand free.
Best regards

Post by **Suso** » Mon Nov 23, 2015 3:58 pm

Ah okay, now I understand, it is a support of an old Holzher Conturo router .
You're right, it is hard to find, I have made some changes to use it in my Kress ... sorry, I can not help because I do not know where to find it.
You could make one with hard plywood and threaded rod, like the one I made for the 3D Router.

Regards,
Suso

lisimario · Post by **lisimario** » Mon Nov 23, 2015 4:46 pm

Tank you very much.