My router table...

Discuss topics related to the Router & Saw Table
Post Reply
Suso
Posts: 2233
Joined: Thu Oct 22, 2015 4:51 pm

My router table...

Post by Suso » Thu Jun 04, 2015 4:02 pm

Photo of my router mecanism finish...works well!

Image

Onofre
Posts: 6
Joined: Thu Jun 04, 2015 8:59 am

My router table...

Post by Onofre » Thu Jun 11, 2015 1:57 pm

Hi,

I would need some infromation about where to get some of the materials:

Threaded inserts, miter gauge bar and track and security power switch.

thanks in advance


Onofre
Posts: 6
Joined: Thu Jun 04, 2015 8:59 am

My router table...

Post by Onofre » Thu Jun 11, 2015 4:29 pm

thanks

Suso
Posts: 2233
Joined: Thu Oct 22, 2015 4:51 pm

My router table...

Post by Suso » Wed Jun 17, 2015 9:19 am

Horizontal router ready to work...

Image

patmos
Posts: 2
Joined: Wed Nov 18, 2015 7:19 pm

My router table...

Post by patmos » Wed Nov 18, 2015 9:58 pm

Hi, I've recently found Your inventions :), and I'm impressed. I have a question about bar and u shape track... measures of track and bar don't match. Did You make some treaded holes and put bolts in it to make the bar wider. The bar has 8mm and inside u-shaped track has 13 mm. Correct me if I'm wrong, or maybe I didn't read Your forum with attention :)

Suso
Posts: 2233
Joined: Thu Oct 22, 2015 4:51 pm

My router table...

Post by Suso » Fri Nov 20, 2015 9:54 am

Hi Patmos,

yes, I made 4mm threaded holes.

About the size of the bar and the u shape track, It will depend on the track you can find. I'll check the plans but the inner measure of one and the outer of the other should be the same. You may need a little bit of oil to make it smooth.

Regards and good luck with the project.
Paoson

Post Reply