Milling bits and router ends

Discuss topics related to the Router & Saw Table
Post Reply
Posts: 1
Joined: Mon Aug 01, 2016 11:11 am

Milling bits and router ends

Post by miky83 » Fri Aug 19, 2016 10:13 am

Goodmonring to all,

I am trying to build the 3D router and yesterday I have purchased a router kress FME-1. Now I am looking for mill bits to use mainly for wood works and I would purchase the same bit I watched in the demostration of 3D router video. I have already purchased common wood router bits like these:
Now I have three questions:

1. Is it enough the end mill with two flat thoots to create the holes/guides of fence as well as to move the axis of this router?
2. Please could you explain me the types of mill bits and the peculiarity of your end bit in the demo video?
3. Is it your bit like this?
If any, please could you address me for purchasing it?

Thanks a lot.


Posts: 1340
Joined: Thu Oct 22, 2015 4:51 pm

Milling bits and router ends

Post by Suso » Fri Aug 19, 2016 12:06 pm

hi friend!
you should take a look at these three articles:




let me know if you still have problems!

Post Reply