Setting the Saw
-
- Posts: 4
- Joined: Thu Nov 24, 2016 3:38 pm
Setting the Saw
I'm about to by the Makita 5104 in advance of designing and building a custom table. I am wondering how do you set the Saw to work with the switch. Isn't there a safety button on the Saw? Maybe it's just as simple as securing the safety button down, but I thought someone might have a more elegant solution.
-
- Posts: 43
- Joined: Thu Oct 15, 2015 5:35 pm
Setting the Saw
hi Marion,
everyone uses a plastic bridle, sometimes the simplest solution is the best! even if it is not very elegant...
you could also open your circular to bypass the switch, but this is not useful if one day you want to use it as a portable tool.
I recomend you to use one like this
everyone uses a plastic bridle, sometimes the simplest solution is the best! even if it is not very elegant...
you could also open your circular to bypass the switch, but this is not useful if one day you want to use it as a portable tool.
I recomend you to use one like this
-
- Posts: 4
- Joined: Thu Nov 24, 2016 3:38 pm
Setting the Saw
Thanks for the quick response. I'll fashion some zip ties to fix the Saw at the on position.
-
- Posts: 4
- Joined: Thu Nov 24, 2016 3:38 pm
Setting the Saw
Another quick question, where can I get the dust extraction port for the Makita 5104? The plastic one I see in the video?
-
- Posts: 2244
- Joined: Thu Oct 22, 2015 4:51 pm
Setting the Saw
I guess you have to buy this accessory apart, in my model was included...
Make sure it works for your circular saw model.
Make sure it works for your circular saw model.
-
- Posts: 4
- Joined: Thu Nov 24, 2016 3:38 pm
Setting the Saw
Thanks, I can't find it online, I may need to make my own.
-
- Posts: 2244
- Joined: Thu Oct 22, 2015 4:51 pm
Setting the Saw
it is a good idea, send me pics when you do it!
-
- Posts: 1
- Joined: Sun Mar 11, 2018 10:03 am
Re: Setting the Saw
Hello Suso,
I own a Makita 5902B table saw.
How do you recommend connecting it to the table plate?
I see only two holes that can recieve screws (see marking in attached picture), is that enough?
I own a Makita 5902B table saw.
How do you recommend connecting it to the table plate?
I see only two holes that can recieve screws (see marking in attached picture), is that enough?
-
- Posts: 2244
- Joined: Thu Oct 22, 2015 4:51 pm
Re: Setting the Saw
hello!
I can't see the image, anyway I recommend you make two more holes to the base of the circular saw. Then you can thread them or use a bolt with a locking nut.
I can't see the image, anyway I recommend you make two more holes to the base of the circular saw. Then you can thread them or use a bolt with a locking nut.