Motor for Sanding Disc or Lathe

Discuss topics related to the Lathe & Sanding Station
Post Reply
engin-yesilyurt
Posts: 1
Joined: Wed May 22, 2019 10:45 am

Motor for Sanding Disc or Lathe

Post by engin-yesilyurt » Wed May 22, 2019 11:01 am

Hi,

I have a circular saw (for table) motor.
Writes the following information on the engine => 800W, 2950 rpm, asynchronous, 230V and 50hz.
No HP information.
Can this engine be used in the Thickness Sander or Lathe project?

Suso
Posts: 982
Joined: Thu Oct 22, 2015 4:51 pm

Re: Motor for Sanding Disc or Lathe

Post by Suso » Wed May 22, 2019 1:25 pm

hello,
could you upload a photo of the motor? I think that motor should have about 1 hp, it's enough for the project.

That motor has more revolutions than the motor that I've used, you will have to change the size of the pulleys to achieve the right revolutions, in this article you will find more information about it.

Post Reply