Homemade Multi-Function Workbench made by Peter Van De Meent:
Peter Van De Meent Plywood Workbench
-
- Posts: 2228
- Joined: Thu Oct 22, 2015 4:51 pm
Re: Peter Van De Meent Plywood Workbench
more photos:
Made Some steel brackets on the legs. The wood was splitting while moving the bench. Good luck tearing this out! 4mm galvanized steel
Made Some steel brackets on the legs. The wood was splitting while moving the bench. Good luck tearing this out! 4mm galvanized steel
-
- Posts: 2228
- Joined: Thu Oct 22, 2015 4:51 pm
Re: Peter Van De Meent Plywood Workbench
finished workbench:
-
- Posts: 2228
- Joined: Thu Oct 22, 2015 4:51 pm
DIY workbench slab flattening jig
@peerenhout:
I ordered Some linear rails of 220cm from aliexpress to make a slab flattening jig. Since I have limited space I use my #multifunctionalworkbench from @paoson_woodworking as work space.
Some m4 nuts in the bench, so I have the rails exactly level, and Some m4 screws so I can take the rails of when not needed.
A pair of shorter rails of 120cm to replace the wooden tray. Now I can flatten bigger slabs and cutting boards!
I ordered Some linear rails of 220cm from aliexpress to make a slab flattening jig. Since I have limited space I use my #multifunctionalworkbench from @paoson_woodworking as work space.
Some m4 nuts in the bench, so I have the rails exactly level, and Some m4 screws so I can take the rails of when not needed.
A pair of shorter rails of 120cm to replace the wooden tray. Now I can flatten bigger slabs and cutting boards!