Lathe & Disc Sander presentation
-
- Posts: 2244
- Joined: Thu Oct 22, 2015 4:51 pm
Lathe & Disc Sander presentation
DIY lathe made completely with birch plywood. As you can see, I've also attached a disc sander on the left side to take advantage of the motor's rotation!
Se trata de un torno casero fabricado totalmente en contrachapado de abedul. Como podéis ver, aprovechando el giro del motor también he acoplado un disco de lijado en el lado izquierdo!
-
- Posts: 3
- Joined: Fri Aug 19, 2016 5:15 pm
Lathe & Disc Sander presentation
Hello,
Thank you for this project but where can I found electric motor ?
Thank you for this project but where can I found electric motor ?
-
- Posts: 2244
- Joined: Thu Oct 22, 2015 4:51 pm
Lathe & Disc Sander presentation
hi James,
at any motor supplier! I used a 1HP single-phase motor. Where you from?
at any motor supplier! I used a 1HP single-phase motor. Where you from?
-
- Posts: 3
- Joined: Fri Aug 19, 2016 5:15 pm
Lathe & Disc Sander presentation
I live in France.
-
- Posts: 1
- Joined: Tue Nov 01, 2016 5:47 pm
Lathe & Disc Sander presentation
this is good or not ?
amazon.fr
amazon.fr
-
- Posts: 2244
- Joined: Thu Oct 22, 2015 4:51 pm
Lathe & Disc Sander presentation
hi Frederic,
that motor has too many revolutions, I install a single-stage 1HP motor with 1500 Rpm.
you will need something like this:
moteur-electrique-en-ligne.fr
moteurselectriques.fr
in Germany
that motor has too many revolutions, I install a single-stage 1HP motor with 1500 Rpm.
you will need something like this:
moteur-electrique-en-ligne.fr
moteurselectriques.fr
in Germany
-
- Posts: 1
- Joined: Sat Nov 12, 2016 6:46 pm
Lathe & Disc Sander presentation
Your tools are incredible! I want to build them all. What made you decide to build instead of buy these tools?
-
- Posts: 2244
- Joined: Thu Oct 22, 2015 4:51 pm
Lathe & Disc Sander presentation
hi Doug
are several reasons...
- to save money.
- for fun.
- because I like to add functions that do not exist in the market.
- If I have breakdowns, they will be easy to solve for me!
- I can adapt the tools to my needs...
thanks!
are several reasons...
- to save money.
- for fun.
- because I like to add functions that do not exist in the market.
- If I have breakdowns, they will be easy to solve for me!
- I can adapt the tools to my needs...
thanks!
-
- Posts: 2
- Joined: Mon Nov 14, 2016 7:41 pm
Lathe & Disc Sander presentation
Good day,
Could you tell me when to expect the plans for the Lathe&Sanding disc online?
Could you tell me when to expect the plans for the Lathe&Sanding disc online?
-
- Posts: 2244
- Joined: Thu Oct 22, 2015 4:51 pm
Lathe & Disc Sander presentation
wrote:Good day,
Could you tell me when to expect the plans for the Lathe&Sanding disc online?
hi Joram,
I'm working on it! tomorrow they'll be ready.